A practical reference on thymosin beta-4: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2025-11-16 and is reviewed periodically as new material appears.
The designation TB-500 circulates in laboratory and catalog contexts without a single agreed definition. Most product listings apply it to an N-terminally acetylated seven-residue fragment of thymosin beta-4, while other listings attach the same label to the full 43-residue protein. Because the term is commercial rather than systematic, two entries bearing identical names may describe different molecules. Any documentation should therefore state which sequence a given sample is claimed to contain.
The fragment most often associated with the name carries the sequence Ac-LKKTETQ, matching residues 17 through 23 of thymosin beta-4. That region holds the actin-binding motif responsible for much of the parent protein's biochemical activity. Apart from N-terminal acetylation the peptide is unmodified and contains no disulfide bonds, so it shows little ordered secondary structure in solution. Full-length thymosin beta-4 is instead a 43-residue polypeptide of roughly 4.9 kDa found widely across mammalian cell types.
Lyophilised peptide is normally reconstituted with sterile water or a neutral buffer shortly before use. Because repeated freeze-thaw cycles can degrade the material, dividing a reconstituted solution into single-use aliquots is a common practice. Working solutions are usually kept cold and protected from light. The exact shelf life depends on concentration, buffer composition, and handling, so it is often determined empirically rather than assumed.
Peptide bonds are susceptible to hydrolysis under extreme pH and to enzymatic cleavage if proteases are present. Heat, oxidising agents, and prolonged exposure to light also contribute to loss of material. Aggregation can occur at high concentrations or in certain buffer systems, and it may not be visible to the eye. Storage at -20 C or below is typical for both powder and aliquoted solutions, and desiccation of the powder is preferred.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography together with mass spectrometry. The chromatogram provides a purity estimate as a percentage of total peak area, while the mass spectrum confirms that the observed mass matches the expected value. Amino acid analysis or tandem mass spectrometry sequencing can provide additional confirmation. Reported purity figures depend on the column, gradient, and detection wavelength, so values from different laboratories are not directly comparable without method details.
| Property | Value | Notes |
|---|---|---|
| Molecular mass | ≈889 Da for the 7-residue fragment | Full-length thymosin beta-4 is ≈4.9 kDa; catalogs differ |
| Appearance | White to off-white powder | Hygroscopic; weight shifts with residual moisture |
| Solubility class | Freely soluble in water | Also dissolves in aqueous buffers; poorly soluble in nonpolar solvents |
| Typical storage temperature | −20 °C, desiccated, protected from light | Once rehydrated, short-term holding at 2-8 °C |
| Typical analytical method | Reversed-phase HPLC with mass spectrometry | Purity by UV absorbance; identity by ESI-MS or MALDI-TOF |
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Lyophilized peptide powder is normally held desiccated at −20 °C, with −80 °C used for longer storage periods. Allowing a sealed vial to reach room temperature before opening is standard practice, because condensation forming on cold powder introduces moisture. Once dissolved, solutions are typically kept cold and shielded from light. Repeated freeze-thaw cycles are avoided because they encourage aggregation and gradual loss of material. These conventions are general to synthetic peptides rather than unique to any one sequence.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
TB-500 is a synthetic peptide preparation marketed under a name derived from thymosin beta-4, a 43-residue actin-binding protein first isolated from thymus tissue. The full-length protein has a reported molecular mass near 4963 Da, while material sold as TB-500 is often described as a fragment containing the actin-binding motif LKKTETQ. Because suppliers use the name inconsistently, published sources sometimes refer to the same label as a fragment, a synthetic copy, or a related analog. This naming ambiguity complicates direct comparison of reports across studies.
Laboratory work on thymosin beta-4 describes binding to monomeric actin and effects on cell migration, angiogenesis, and inflammatory signaling in cultured cells. Animal models have examined skin, corneal, and cardiac repair after injury, with outcomes reported mainly in preclinical literature. Most of that evidence concerns the parent protein rather than preparations labelled TB-500, so extrapolation from animal findings to a specific commercial product remains uncertain. Whether the two behave identically in living systems has not been established in controlled human studies.
TB-500 is a research peptide whose sequence matches residues 17 to 23 of thymosin beta-4, a 43-residue protein present in most mammalian cells. The chain is seven amino acids long, written as LKKTETQ, and is normally supplied with an acetyl group on the N-terminus. Suppliers list it as a lyophilised powder under the code name TB-500, and the same sequence appears elsewhere in catalogues as the thymosin beta-4 actin-binding fragment. The label is commercial rather than systematic, so no single authority fixes exactly what TB-500 denotes.
Thymosin beta-4 was isolated from calf thymus in the early 1980s and later characterised as an abundant intracellular actin-sequestering protein. Interest in short synthetic fragments grew once the actin-binding motif had been mapped to the middle of the sequence. TB-500 came out of that line of work as a truncated analogue rather than a natural isolate, and it is now sold mainly to laboratories. Published studies on the fragment have been largely in vitro or in animal models, and controlled human trials remain sparse, so claims about effects in people rest on extrapolation.
The Hmd holoenzyme includes the protein homodimer as well as its associated iron-containing cofactor. Several species of methanogens have been characterized that express enzymes in the Hmd hydrogenase family. Between species the enzyme is found with differing numbers of sub-units and some minor amino acid sequence variations. The monomer is approximately 45,000 Da in mass, although this value varies from species to species. The enzymatic activity of the enzyme is lost upon exposure to sunlight or UV. Photolysis causes the release of an iron atom and two molecules of carbon monoxide. In the holoenzyme the Fe and CO molecules are found associated with a 542 Da cofactor.
Because DNA collects mutations over time, which are then inherited, it contains historical information, and, by comparing DNA sequences, geneticists can infer the evolutionary history of organisms, their phylogeny. This field of phylogenetics is a powerful tool in evolutionary biology. If DNA sequences within a species are compared, population geneticists can learn the history of particular populations. This can be used in studies ranging from ecological genetics to anthropology. DNA as a storage device for information has enormous potential since it has much higher storage density compared to electronic devices. However, high costs, slow read and write times (memory latency), and insufficient reliability has prevented its practical use.
Loading buffers often contain anionic dyes that are visible under the visible light spectrum, and are added to the gel before the nucleic acid. Tracking dyes should not be reactive so as not to alter the sample, and move down the gel with the DNA or RNA sample. Commonly used color markers include Bromophenol blue, Cresol Red, Orange G and Xylene cyanol. Xylene and bromophenol blue are the most commonly used dyes. Generally speaking, Orange G migrates faster than bromophenol blue, which migrates faster than xylene cyanol, but the apparent "sizes" of these dyes (compared to DNA molecules) varies with the concentration of agarose and the buffer system used. For instance, in a 1% agarose gel made in TAE buffer (Tris-acetate-EDTA), xylene cyanol migrates at the speed of a 3000 base pair (bp) molecule of DNA and bromophenol blue migrates at 400 bp. However, in a 1% gel made in TBE buffer (Tris-borate-EDTA), they migrate at 2000 bp and 250 bp respectively.
Sources: en.wikipedia.org
=== Metabolic manipulation === Engineering of metabolic processes have been achieved through cell-free systems. Bujara et al., for example, were able to use glycolytic network extracts, consisting of enzymes from E. coli that produced dihydroxyacetone phosphate, to analyze in real-time the metabolite concentrations while altering enzyme levels, with the result of optimal production of dihydroxyacetone phosphate. Further, Calhoun and Swartz were able to use a glycolytic intermediate to fuel a cell-free system, enabling relatively inexpensive ATP generation compared to reagent usage in phosphoenolpyruvate reactions.
In August 1950, the Lao Prince Souphanouvong convened the first congress of the Pathet Lao, which was supported by Viet Minh and served as the vehicle for the communist challenge to French rule. On 13 August 1950, he was elected President of the Congress of the Pathet Lao, which met at the Việt Minh headquarters in Tuyen Quang, North Vietnam. In 1953, Pathet Lao fighters accompanied an invasion of Laos from Vietnam led by Viet Minh forces; they established a government at Viengxay in Houaphanh province, northeast Laos.
The most recognizable and most common form of dwarfism in humans is achondroplasia, which accounts for 70% of dwarfism cases, and occurs in 4 to 15 out of 100,000 live births. It produces rhizomelic short limbs, increased spinal curvature, and distortion of skull growth. In achondroplasia the body's limbs are proportionately shorter than the trunk (abdominal area), with a larger head than average and characteristic facial features. Achondroplasia is an autosomal dominant disorder caused by the presence of an altered allele in the genome. If a pair of achondroplasia alleles are present, the result is fatal, usually perinatally. Achondroplasia is a mutation in the fibroblast growth factor receptor 3. In the context of achondroplasia, this mutation causes FGFR3 to become constitutively active, inhibiting bone growth.
Sources: en.wikipedia.org
Usually not, though usage overlaps. The label most often refers to a short acetylated fragment of the parent protein, while thymosin beta-4 itself is the full 43-residue molecule. Because suppliers vary, a sequence statement is needed to settle the question for any particular lot.
The name is a commercial label rather than a systematic chemical designation, so different vendors and papers attach it to different sequences. Some treat it as a fragment and others as the whole protein. Comparing two reports therefore requires checking what each one actually analyzed.
Typically it reflects the relative area of the main peak in a reversed-phase chromatogram at a given wavelength. It does not confirm the amino acid sequence, the counter-ion, or the amount of peptide by mass. Identity is normally established by a separate mass measurement.
The lyophilised powder is typically held at -20 C or lower in a dry, dark place. Reconstituted solutions are aliquoted and frozen to avoid repeated freeze-thaw cycles.