TB-500 comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Updated 2026-08-01. Numbers and descriptions here follow the published literature rather than marketing material.
Lyophilized peptide powder is normally held desiccated at −20 °C, with −80 °C used for longer storage periods. Allowing a sealed vial to reach room temperature before opening is standard practice, because condensation forming on cold powder introduces moisture. Once dissolved, solutions are typically kept cold and shielded from light. Repeated freeze-thaw cycles are avoided because they encourage aggregation and gradual loss of material. These conventions are general to synthetic peptides rather than unique to any one sequence.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
| Property | Value | Notes |
|---|---|---|
| Dosage form | Lyophilized powder in sealed vial | Reconstituted before analytical or laboratory use |
| Reconstitution solvent | Sterile or bacteriostatic water | Bacteriostatic water limits microbial growth in multi-use vials |
| Typical working pH | Near neutral, buffered | Strongly acidic or basic conditions promote degradation |
| Stability indicator | Loss of main HPLC peak over time | Aggregation and oxidation are common degradation routes |
| Documentation | Batch certificate of analysis | Covers identity, purity and sometimes sterility testing |
Lyophilised peptide is normally reconstituted with sterile water or a neutral buffer shortly before use. Because repeated freeze-thaw cycles can degrade the material, dividing a reconstituted solution into single-use aliquots is a common practice. Working solutions are usually kept cold and protected from light. The exact shelf life depends on concentration, buffer composition, and handling, so it is often determined empirically rather than assumed.
Peptide bonds are susceptible to hydrolysis under extreme pH and to enzymatic cleavage if proteases are present. Heat, oxidising agents, and prolonged exposure to light also contribute to loss of material. Aggregation can occur at high concentrations or in certain buffer systems, and it may not be visible to the eye. Storage at -20 C or below is typical for both powder and aliquoted solutions, and desiccation of the powder is preferred.
The fragment most often associated with the name carries the sequence Ac-LKKTETQ, matching residues 17 through 23 of thymosin beta-4. That region holds the actin-binding motif responsible for much of the parent protein's biochemical activity. Apart from N-terminal acetylation the peptide is unmodified and contains no disulfide bonds, so it shows little ordered secondary structure in solution. Full-length thymosin beta-4 is instead a 43-residue polypeptide of roughly 4.9 kDa found widely across mammalian cell types.
Material sold under this label typically arrives as a freeze-dried powder in a sealed vial with a certificate of analysis. Such certificates usually report reversed-phase chromatography purity plus a mass confirmation, and stated purities commonly sit between 95 and 99 percent. Counter-ion identity, residual trifluoroacetate, water content, and peptide net weight are separate specifications that a certificate may or may not include. A purity figure alone does not establish sequence identity, so independent mass verification remains the practical check.
==== Prostaglandin E1 (PGE1) agonists ==== Alprostadil (Caverject; Prostaglandin E1) – prostaglandin E1 (PGE1) agonist – erectile dysfunction [129] Alprostadil alfadex (alprostadil alfadex complex; alprostadil-alpha-cyclodextrin; Edex; Prostaglandin E1-α-cyclodextrin complex; Prostandin; Prostavasin; Rigidur; Sugiran; Vasaprostan; Vasoprost; Viridal) – prostaglandin E1 (PGE1) agonist – erectile dysfunction [130] Alprostadil topical (Alprox-TD; Befar; Cold Chain Vitaros; Femprox; RayVa; Room Temperature Vitaros; Virirec; Vitaros; Vytaros; WC-3036) – prostaglandin E1 (PGE1) agonist – erectile dysfunction [131]
=== Indian Farmers Fertiliser Cooperative (IFFCO) === Indian Farmers Fertiliser Cooperative Limited (IFFCO) was registered on November 3, 1967, as a Multi-Unit Co-operative Society. On the enactment of the Multistate Co-operative Societies Act 2002, the Society is deemed to be registered as a Multistate Co-operative Society. The Society is primarily engaged in production and distribution of fertilisers. The byelaws of the Society provide a board frame work for the activities of IFFCO as a Co-operative Society. At IFFCO, the thirst for ever improving the services to farmers and member cooperatives is insatiable, commitment to quality is isurmountable and harnessing of mother earths' bounty to drive hunger away from India in an ecologically sustainable manner is the prime mission. See also:
=== Graphene fiber === In 2011, researchers reported a novel yet simple approach to fabricating graphene fibers from chemical vapor deposition-grown graphene films. The method was scalable and controllable, delivering tunable morphology and pore structure by controlling the evaporation of solvents with suitable surface tension. Flexible all-solid-state supercapacitors based on these graphene fibers were demonstrated in 2013. In 2015, researchers intercalated small graphene fragments into the gaps formed by larger, coiled graphene sheets. They found that after annealing, this provided pathways for conduction, while the fragments helped reinforce the fibers. The resulting fibers offered better thermal and electrical conductivity and mechanical strength. Thermal conductivity reached 1,290 W/m/K (1,290 watts per metre per kelvin), while tensile strength reached 1,080 MPa (157,000 psi). In 2016, kilometer-scale continuous graphene fibers with outstanding mechanical properties and excellent electrical conductivity were produced by high-throughput wet-spinning of graphene oxide liquid crystals followed by graphitization through a full-scale synergetic defect-engineering strategy. The graphene fibers with superior performances promise wide applications in functional textiles, lightweight motors, microelectronic devices, etc. Tsinghua University in Beijing, led by Wei Fei of the Department of Chemical Engineering, claims to be able to create a carbon nanotube fiber that has a tensile strength of 80 GPa (12,000,000 psi).
Sources: en.wikipedia.org
Hydrocodone/paracetamol (also known as hydrocodone/acetaminophen) is the combination of the pain medications hydrocodone (an opioid) and paracetamol (acetaminophen). It is used to treat moderate to severe pain. It is taken by mouth. Recreational use is common in the United States. Common side effects include dizziness, sleepiness, constipation, and vomiting. Serious side effects include addiction, decreased rate of breathing, low blood pressure, severe allergic reactions, and liver failure. Use during pregnancy may harm the fetus. Use with alcohol is not recommended. Hydrocodone works by binding to the mu-opioid receptor. How paracetamol works is unclear but may involve blocking the creation of prostaglandins. Hydrocodone/paracetamol was approved for medical use in the United States in 1982. In the United States, it is a schedule II controlled substance. In 2023, it was the 25th most commonly prescribed medication in the United States, with more than 21 million prescriptions. It is not available in the United Kingdom, though the combination codeine/paracetamol (co-codamol) is. It is sold under the brand names Vicodin and Norco among others.
=== Comparison to other agents === Compared with azathioprine it has higher incidence of diarrhea, and no difference in risk of any of the other side effects in transplant patients. Mycophenolic acid is 15 times more expensive than azathioprine.
== History == Catalase was first noticed in 1818 by Louis Jacques Thénard, who discovered hydrogen peroxide (H2O2). Thénard suggested its breakdown was caused by an unknown substance. In 1900, Oscar Loew was the first to give it the name catalase, and found it in many plants and animals. In 1937 catalase from beef liver was crystallized by James B. Sumner and Alexander Dounce and the molecular weight was measured in 1938. The amino acid sequence of bovine catalase was determined in 1969, and the three-dimensional structure in 1981.
Sources: en.wikipedia.org
Desiccated storage at −20 °C is conventional, with −80 °C for extended periods. Vials should be warmed to room temperature before opening to prevent condensation on the powder.
It usually reports batch-specific results for purity by chromatography, identity by mass spectrometry, and sometimes peptide content and residual solvents. It applies only to the batch tested, not to a supplier's wider stock.
Purity describes the proportion of the chromatographic signal from the target compound, while peptide content measures how much of the vial's physical mass is peptide. Counter-ions, water and residual acid make up the remainder, so content values are commonly lower.
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.