The short version of TB-500 fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-08-05 and is reviewed periodically as new material appears.
Peptide bonds are susceptible to hydrolysis under extreme pH and to enzymatic cleavage if proteases are present. Heat, oxidising agents, and prolonged exposure to light also contribute to loss of material. Aggregation can occur at high concentrations or in certain buffer systems, and it may not be visible to the eye. Storage at -20 C or below is typical for both powder and aliquoted solutions, and desiccation of the powder is preferred.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography together with mass spectrometry. The chromatogram provides a purity estimate as a percentage of total peak area, while the mass spectrum confirms that the observed mass matches the expected value. Amino acid analysis or tandem mass spectrometry sequencing can provide additional confirmation. Reported purity figures depend on the column, gradient, and detection wavelength, so values from different laboratories are not directly comparable without method details.
The compound is most often distributed as a lyophilized powder, appearing white to off-white and forming a loose cake or fluffy solid. It is hygroscopic to some degree, so brief exposure to humid air can add water weight and complicate weighing. The peptide dissolves readily in water and in neutral aqueous buffers, and aqueous solubility is generally described as high, well above the concentrations used in typical assays. Some polar organic solvents are also usable, which matters when a concentrated stock is prepared before dilution into buffer.
Storage recommendations center on keeping the dry powder cold, dry, and dark. A freezer at -20 degrees Celsius or below is conventional, and desiccant is often included to limit moisture uptake. Once dissolved, the peptide is less stable, and solutions are typically kept frozen and thawed only once. Repeated freeze-thaw cycles are a common source of losses because they promote aggregation and adsorption to container surfaces. Working aliquots are therefore prepared in advance, and glass or low-binding plastic is usually preferred over ordinary laboratory plastic.
| Property | Value | Notes |
|---|---|---|
| Purity determination | Reversed-phase HPLC | UV detection commonly at 214 nm |
| Mass confirmation | Mass spectrometry | Compared against theoretical 888.5 Da |
| Powder storage | -20 C or below | Dry and protected from light |
| Reconstituted storage | Aliquoted and frozen | Avoid repeated freeze-thaw cycles |
| Reconstitution solvent | Sterile water or neutral buffer | Avoid extreme pH conditions |
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
Thymosin beta-4 itself is a natural peptide of 43 residues found in many cell types and body fluids. Its best-characterised function is binding and sequestering actin monomers, which influences cytoskeletal dynamics. The sequence most often associated with TB-500, LKKTETQ, corresponds to part of that actin-binding region. A different fragment, Ac-SDKP, is also derived from the same parent peptide and is studied in its own right, which is one reason discussions of thymosin fragments can become confusing. The two are structurally distinct and are not interchangeable.
Interest in the fragment grew during the 1990s and 2000s, when it moved from laboratory work into sports and supplement markets. Anti-doping bodies added thymosin beta-4 fragments to prohibited lists, and a small number of adverse analytical findings have been reported in competition testing. Published controlled human trials remain scarce. Most mechanistic evidence comes from cell culture and animal models, and those studies examine endpoints such as cell migration, wound closure and inflammation markers. That evidence supports research interest but does not establish clinical benefit, and broad regenerative claims should be read as unverified.
TB-500 refers to a synthetic peptide fragment derived from the actin-binding region of thymosin beta-4, a protein present in most mammalian cells. The full protein contains forty-three amino acids, while the commonly sold fragment is a much shorter acetylated sequence, often cited as LKKTETQ. The fragment retains part of the actin-binding motif but lacks the remainder of the parent protein. Material sold under this name is usually lyophilized powder intended for laboratory research, and it is not a finished pharmaceutical product.
Proposed activity centers on actin sequestration and on the movement of cells during repair processes. In cell culture and animal models, the fragment has been associated with migration, tube formation, and tissue remodeling. These observations are frequently described as preliminary, because most published work uses rodent or in vitro systems rather than controlled human trials. Whether the short fragment reproduces the effects of the full protein remains an open question, and the relationship between dose, route, and measured outcome is not well characterized.
The compound circulates in the literature as a research reagent rather than an approved therapeutic. Regulatory agencies in several countries have not authorized it for medical use, and sporting bodies list related thymosin beta-4 peptides among prohibited substances. Suppliers typically market it with a purity figure and a certificate of analysis, while peer-reviewed clinical reports remain sparse. Discussions therefore often separate laboratory findings from anecdotal reports, and reviewers tend to note the small size and methodological limits of the available studies.
=== PTQ implant === This is a silicone biomaterial, marketed as "PTQ" or "Bioplastique". It is polydimethylsiloxane elastomer particles suspended in a biocompatible carrier hydrogel of poly-N-vinyl-pyrrolidone (povidone). Significantly more publications exist which investigate this material compared to the other materials, and it has been the most widely used bulking material used for FI. Publications used inter-sphincteric or within IAS injection sites via the trans-sphincteric route. The particles are in the range 100–450 μm with smaller particles in the gel. Therefore there is a possibility of migration and granuloma formation. There are also concerns about a link between autoimmune diseases and silicone. The bulking agent is very viscous which makes it difficult to inject. After injection there is irregular collagen deposition around and inside the implant.
==== UK ==== Classified as a controlled drug, listed under Schedule IV, Part I (CD Benz POM) of the Misuse of Drugs Regulations 2001, allowing possession with a valid prescription. The Misuse of Drugs Act 1971 makes it illegal to possess the drug without a prescription, and for such purposes, it is classified as a Class C drug.
Amino acid score is used to determine if a protein is complete. It is used along with the measure of protein digestibility that refers to how well a given protein is digested, to compare the proportion of essential amino acids found in one protein to the proportion in a "reference protein" considered to be complete.
Sources: en.wikipedia.org
=== Parasitic infections === HLA-G has been shown to modulate the body's response to parasitic diseases. Recent studies have emerged suggesting a link between HLA-G and Plasmodium falciparum, which is one of the most dangerous malaria species. In pregnant women, P. falciparum can infect the placenta, causing low birth weights and other complications. High levels of soluble HLA-G have been linked to higher instances of low birth weights. There is also a link between HLA-G expression and human African trypanosomiasis (HAT). People with higher levels of soluble HLA-G are more likely to be diagnosed with the disease. There may also be genetic differences driving the instance and severity of HAT, as a few single-nucleotide polymorphisms have been associated with higher levels of HAT. There is also an effect in toxoplasmosis infections in pregnant women, where HLA-G is upregulated to protect the fetus from inflammation. Treatment of cells with IL-10 leads to a downregulation of HLA-G, which could be an avenue for therapy in instances where too much HLA-G is produced. Individuals with visceral leishmaniasis infections also have higher levels of soluble HLA-G, which may be due to a strategy by Leishmania to evade the immune system.
== Structure == Two identified transcript variants are expressed in several tissues and are evolutionarily conserved in fish and swine. One transcript, 1a, excises an intron and encodes the functional protein; this protein is the receptor for the ghrelin ligand and defines a neuroendocrine pathway for growth hormone release. The second transcript (1b) retains the intron and does not function as a receptor for ghrelin; however, it may function to attenuate activity of isoform 1a. GHS-R1a is a member of the G-protein-coupled receptor (GPCR) family. Previous studies have shown that GPCRs can form heterodimers, or functional receptor pairs with other types of G-protein coupled receptors (GPCRs). Various studies suggest that GHS-R1a specifically forms dimers with the following hormone and neurotransmitter receptors: somatostatin receptor 5, dopamine receptor type 2 (DRD2), melanocortin-3 receptor (MC3R), and serotonin receptor type 2C (5-HT2c receptor). See "Function" section below for details on the purported functions of these heterodimers.
The origin and first recorded use of the term megacap (or any of its various spellings), in relation to stock capitalization, is unclear. It dates back to at least 1997, if not earlier. The S&P 100 was launched on June 15, 1983. The Russell Top 200 Index was launched on September 1, 1992. The Fidelity Mega Cap Stock Fund's inception was on December 28, 1998. The Russell Top 50 Mega Cap Index was launched on January 1, 2005. Also in 2005, investment advisory executive Richard Imperiale noted that some investors were classifying "the top 10 percent of companies by market cap" into a mega cap segment of the stock market. In 2009, the third edition of Stock Investing For Dummies defined mega caps (and ultra caps) as companies with market caps over $50 billion. Subsequent editions used that definition until 2020, when the sixth edition redefined them as having market caps over $200 billion. The 2023 version, retitled Investing in Stocks For Dummies, used the same definition as the sixth edition. The Morningstar US Mega Cap Index was established on March 31, 2011. In 2011, Investing Demystified defined mega-caps as companies with market caps of at least $25 billion, whereas in the same year, The Complete Idiot's Guide to Stock Investing defined them as having market caps at least $50 billion. That's equivalent to $34 billion and $69 billion, respectively, in 2024 using GDP deflator adjustment. In 2014, Asset Allocation Demystified stated that a typical mega cap company had a market cap of over $50 billion. The S&P 500 Top 50 Index was launched on November 30, 2015.
Sources: en.wikipedia.org
The lyophilised powder is typically held at -20 C or lower in a dry, dark place. Reconstituted solutions are aliquoted and frozen to avoid repeated freeze-thaw cycles.
Mass spectrometry is the usual confirmatory method because it measures the intact mass. Reversed-phase chromatography is used alongside it to estimate purity.
Not directly. Reported percentages depend on the chromatographic method, detection wavelength, and integration criteria, so the underlying method details matter.
Short transit at ambient temperature is generally tolerated, but long-term storage at room temperature is not recommended. Heat, moisture, and light all accelerate degradation. Cold, dry, dark storage is the conventional choice.