TB-500 comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-05-30. Where a claim depends on a specific study, the study is described rather than over-claimed.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
Identity and purity are normally assessed with reversed-phase high-performance liquid chromatography, paired with mass spectrometry to confirm molecular mass. A certificate of analysis reports a purity percentage, usually derived from chromatographic peak area, but that figure does not by itself prove a correct sequence or the absence of counterions. Independent verification may include amino acid analysis or peptide mapping. Batch-to-batch variation is a documented concern in the research chemical market, and the gap between a quoted purity value and actual peptide content can be substantial when the material is a salt or retains residual water.
Lyophilized peptide arrives as a dry cake that should stay sealed until use. Reconstitution is generally performed with sterile water or a buffered solution, and the resulting liquid should be handled gently to limit mechanical stress. Repeated freeze-thaw cycles are widely described as harmful to short peptides, so dividing a reconstituted batch into single-use portions is a common practice. Laboratories also record the solvent, concentration, and date of preparation on the vial label to keep later measurements traceable.
Dry powder is commonly held at minus twenty degrees Celsius, with some suppliers recommending lower temperatures for long-term archival storage. Once dissolved, solutions are typically kept cold and protected from light, since aqueous peptide solutions can lose integrity through hydrolysis or oxidation over time. Stability data specific to this fragment are limited in the public literature, and much of the guidance comes from general peptide handling practice rather than from controlled degradation studies. Users therefore treat stated shelf lives as approximate rather than fixed.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Calculated for the acetylated heptapeptide |
| Molecular weight | ~889 Da | Monoisotopic mass approximately 889.0 Da |
| Amino acid sequence | Ac-LKKTETQ | N-terminal acetylated seven-residue peptide |
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid |
| Solubility class | Water-soluble | Peptides of this size generally dissolve in aqueous media |
Interest in the compound comes largely from studies of the parent protein, which participates in actin sequestration, cell migration and tissue repair processes. Whether a short fragment reproduces those activities is a separate question that remains open in the published record. Many summaries describe mechanisms by analogy to thymosin beta-4 rather than from direct measurements on the fragment. Claims about activity should be treated as provisional unless a cited study specifies the exact peptide, its purity and the assay used.
TB-500 is a laboratory label applied to a short synthetic peptide that is widely described as a fragment of thymosin beta-4, an actin-binding protein present in most mammalian cells. Suppliers and review articles usually present TB-500 as the N-terminal region of that protein, but the exact sequence attached to the name is not consistent across sources. Some product descriptions list a seven-residue chain; others use the label loosely for the parent protein itself. Because of that variation, any technical discussion of TB-500 needs to state which sequence is meant.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
The earliest buildings, such as Indianapolis White Castle #3, built in 1927, had exteriors of white enamel-glazed brick and interiors of enameled steel. The Indianapolis unit was in operation until 1979, making it, at the time of its closure, the longest-operating fast food restaurant in the country. The company constructed this style of building from 1924 to 1929. White Castle Building No. 8 in Minneapolis, Minnesota, originally built in 1936 and remodeled, is an example of the chain's buildings with prefabricated white porcelain enamel on steel exteriors. The building measured 28 feet (8.5 m) by 28 feet (8.5 m) and was designed to resemble the Chicago Water Tower, with octagonal buttresses, crenelated towers, and a parapet wall. The success of White Castle led to numerous imitators. Restaurants copied the distinctive architecture of White Castle buildings, as well as created confusion for consumers by using a similar name. The first of these imitators in Wichita was Little Kastle. Many competitors created their names with a play on the White Castle name. Some restaurant chains just replaced the word "Castle" with their own word (Cabin, Cap, Clock, Crescent, Diamond, Dome, Fortress, Grille, House, Hut, Kitchen, Knight, Log, Manna, Mill, Palace, Plaza, Shop, Spot, Tavern, Tower, Turret, Wonder), while others chose to replace "White" with another color or adjective (Blue, King's, Little, Magic, Modern, Prince's, Red, Royal, Silver). Some of the other imitators included Castle Blanca, Blue Beacon, Blue Bell, Blue Tower, Krystal, Red Barn, Red Lantern, and Klover Kastle.
These types of submarines were first used during the Russo-Japanese War of 1904–05. Due to the blockade at Port Arthur, the Russians sent their submarines to Vladivostok, where by 1 January 1905 there were seven boats, enough to create the world's first "operational submarine fleet". The new submarine fleet began patrols on 14 February, usually lasting for about 24 hours each. The first confrontation with Japanese warships occurred on 29 April 1905 when the Russian submarine Som was fired upon by Japanese torpedo boats, but then withdrew.
=== Bibliography === Emsley, John (2003). Nature's building blocks: an A-Z guide to the elements. Oxford University Press. p. 351 ff. ISBN 978-0-19-850340-8. Retrieved 27 June 2015. Greenwood, Norman N.; Earnshaw, Alan (1997). Chemistry of the Elements (2nd ed.). Butterworth-Heinemann. doi:10.1016/C2009-0-30414-6. ISBN 978-0-08-037941-8. Keller, Cornelius; Wolf, Walter; Shani, Jashovam (15 October 2011). "Radionuclides, 2. Radioactive Elements and Artificial Radionuclides". Ullmann's Encyclopedia of Industrial Chemistry. Weinheim: Wiley-VCH. pp. 97–98. doi:10.1002/14356007.o22_o15. ISBN 978-3-527-30673-2. Kirby, H.W. & Salutsky, Murrell L. (December 1964). The Radiochemistry of Radium (Report). crediting UNT Libraries Government Documents Department – via University of North Texas, UNT Digital Library. Alternate source: https://sgp.fas.org/othergov/doe/lanl/lib-www/books/rc000041.pdf
== Function == Arginase catalyzes the hydrolysis of arginine to ornithine and urea. In addition to arginase-1, there also exists a second type arginase-2, which differs in its tissue distribution, subcellular localization, immunologic crossreactivity and physiologic function. The type I isoform encoded by this gene, is a cytosolic enzyme and expressed predominantly in the liver as a component of the urea cycle. Inherited deficiency of this enzyme results in argininemia, an autosomal recessive disorder characterized by hyperammonemia. Two transcript variants encoding different isoforms have been found for this gene.
=== Projects === Focke-Wulf 1000x1000x1000 – series of bomber designs, 1944. Focke-Wulf Project I – single-seat jet fighter, 1943. Focke-Wulf Project II Focke-Wulf Project III Focke-Wulf Project VII "Flitzer" – fighter project, 1944. Focke-Wulf Project VIII – turboprop powered fighter-bomber project, also designated Fw 281 Focke Rochen – 1950s VTOL fighter project Focke-Wulf Super Lorin – Ramjet-rocket combo powered fighter Focke-Wulf Fw 354 Triebflügel – tail-sitter VTOL interceptor design Focke-Wulf TO Project Focke-Wulf Volksjäger – rocket-powered interceptor fighter project Focke-Wulf VTOL Project
Sources: en.wikipedia.org
Other notable mutations identified in ICP patients include ones in the farnesoid X receptor (FXR), a nuclear receptor in hepatocytes which activates transcription of MDR3 and BSEP upon binding intracellular bile acids, thereby increasing canalicular bile efflux.
=== Prehistory === The site of modern-day Moscow has been inhabited since prehistoric times. Among the earliest archaeological discoveries were relics of the Lyalovo culture, which experts assign to the Neolithic period. These relics confirm that the area's first inhabitants were hunters and gatherers. Around 950 AD, two Slavic tribes—Vyatichi and Krivichi—settled in the area. The Vyatichi may have formed the majority of Moscow's indigenous population.
Group 14 is also a good fit in terms of thermodynamic properties such as ionisation energy and electron affinity, but hydrogen cannot be tetravalent. Thus none of the three placements are entirely satisfactory, although group 1 is the most common placement (if one is chosen) because of the electron configuration and the fact that the hydron is by far the most important of all monatomic hydrogen species, being the foundation of acid-base chemistry. As an example of hydrogen's unorthodox properties stemming from its unusual electron configuration and small size, the hydrogen ion is very small (radius around 150 fm compared to the 50–220 pm size of most other atoms and ions) and so is nonexistent in condensed systems other than in association with other atoms or molecules. Indeed, transferring of protons between chemicals is the basis of acid-base chemistry. Also unique is hydrogen's ability to form hydrogen bonds, which are an effect of charge-transfer, electrostatic, and electron correlative contributing phenomena. While analogous lithium bonds are also known, they are mostly electrostatic. Nevertheless, hydrogen can take on the same structural role as the alkali metals in some molecular crystals, and has a close relationship with the lightest alkali metals (especially lithium).
A check valve, non-return valve, reflux valve, retention valve, foot valve, or one-way valve is a valve that normally allows fluid (liquid or gas) to flow through it in only one direction. Check valves are two-port valves, meaning they have two openings in the body, one for fluid to enter and the other for fluid to leave. There are various types of check valves used in a wide variety of applications. Check valves are often part of common household items. Although they are available in a wide range of sizes and costs, check valves generally are very small, simple, and inexpensive. Check valves work automatically and most are not controlled by a person or any external control; accordingly, most do not have any valve handle or stem. The bodies (external shells) of most check valves are made of plastic or metal. An important concept in check valves is the cracking pressure which is the minimum differential upstream pressure between inlet and outlet at which the valve will operate. Typically the check valve is designed for and can therefore be specified for a specific cracking pressure.
=== Oxanorbornadiene cycloaddition === The oxanorbornadiene cycloaddition is a 1,3-dipolar cycloaddition followed by a retro-Diels Alder reaction to generate a triazole-linked conjugate with the elimination of a furan molecule. Preliminary work has established its usefulness in peptide labeling experiments, and it has also been used in the generation of SPECT imaging compounds. More recently, the use of an oxanorbornadiene was described in a catalyst-free room temperature "iClick" reaction, in which a model amino acid is linked to the metal moiety, in a novel approach to bioorthogonal reactions.
Sources: en.wikipedia.org
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.
No. Thymosin beta-4 is a 43-amino-acid protein, while TB-500 represents only a short N-terminal segment. The two should not be treated as interchangeable in experimental design.
It is often called a thymosin beta-4 fragment, Tβ4 fragment, or Ac-LKKTETQ. The name TB-500 is mainly a commercial or catalog label rather than a formal chemical name.
Dry lyophilized powder is usually kept frozen, desiccated, and out of direct light. Sealed vials are not opened until needed, because moisture uptake can degrade short peptides. Longer archival storage is often done at lower temperatures than routine working stock.