The short version of counter-ion fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-03-22 and is reviewed periodically as new material appears.
Identity and purity are checked with chromatographic and mass spectrometric methods. Reverse-phase high-performance liquid chromatography separates the peptide from related impurities, while mass spectrometry confirms the expected molecular mass. A certificate of analysis may report a purity percentage, but the laboratory should still verify the material independently. Common quality concerns include truncated sequences, deamidation, oxidation, and residual solvents from synthesis. Because TB-500 is short, some impurities can differ from the target by only a few mass units.
Reconstitution practices affect downstream measurements. The dry powder is typically dissolved in sterile water or a suitable aqueous buffer, then mixed gently rather than vortexed at high speed. Visible particles or cloudiness suggest incomplete dissolution or contamination and should be investigated. For long-term storage, aliquots should be labeled with concentration, solvent, and date. Open questions include how different buffers alter peptide conformation and whether specific container materials adsorb the peptide. Those variables can change apparent concentration in assays even when the chemical identity is correct.
Lyophilized TB-500 is hygroscopic and should be kept dry before use. The usual storage recommendation for the solid is -20 °C, protected from light and moisture. Once dissolved, the peptide is less stable, and repeated freeze-thaw cycles can promote aggregation or degradation. Laboratories often divide a reconstituted solution into single-use aliquots and store them at -80 °C. Exact stability limits depend on buffer, pH, and concentration, so published data do not define a single universal condition.
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
| Property | Value | Notes |
|---|---|---|
| Storage temperature (dry) | -20 °C | Protected from light and moisture |
| Storage temperature (solution) | -80 °C | Single-use aliquots recommended |
| Identity assay | LC-MS or MALDI-TOF | Confirms mass near 889 Da |
| Purity assay | RP-HPLC | Reports main peak percentage |
| Common impurities | Truncated peptides, deamidated forms | Arise from synthesis or storage |
The fragment most often associated with the name carries the sequence Ac-LKKTETQ, matching residues 17 through 23 of thymosin beta-4. That region holds the actin-binding motif responsible for much of the parent protein's biochemical activity. Apart from N-terminal acetylation the peptide is unmodified and contains no disulfide bonds, so it shows little ordered secondary structure in solution. Full-length thymosin beta-4 is instead a 43-residue polypeptide of roughly 4.9 kDa found widely across mammalian cell types.
Material sold under this label typically arrives as a freeze-dried powder in a sealed vial with a certificate of analysis. Such certificates usually report reversed-phase chromatography purity plus a mass confirmation, and stated purities commonly sit between 95 and 99 percent. Counter-ion identity, residual trifluoroacetate, water content, and peptide net weight are separate specifications that a certificate may or may not include. A purity figure alone does not establish sequence identity, so independent mass verification remains the practical check.
The designation TB-500 circulates in laboratory and catalog contexts without a single agreed definition. Most product listings apply it to an N-terminally acetylated seven-residue fragment of thymosin beta-4, while other listings attach the same label to the full 43-residue protein. Because the term is commercial rather than systematic, two entries bearing identical names may describe different molecules. Any documentation should therefore state which sequence a given sample is claimed to contain.
Lyophilized peptide powder is normally held desiccated at −20 °C, with −80 °C used for longer storage periods. Allowing a sealed vial to reach room temperature before opening is standard practice, because condensation forming on cold powder introduces moisture. Once dissolved, solutions are typically kept cold and shielded from light. Repeated freeze-thaw cycles are avoided because they encourage aggregation and gradual loss of material. These conventions are general to synthetic peptides rather than unique to any one sequence.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
TB-500 is a synthetic seven-amino-acid peptide with the sequence LKKTETQ, corresponding to residues 17 through 23 of the protein thymosin beta-4. The N-terminus is typically acetylated in the described form, giving a monoisotopic mass near 888.5 Da and an average mass of about 889 Da. The designation TB-500 is a catalogue label rather than a formal chemical name, and the same sequence appears in the literature under several alternative abbreviations. It is handled as a research reagent rather than a pharmaceutical product.
Thymosin beta-4 is a 43-residue actin-binding protein found in most mammalian cell types, where it participates in cytoskeletal regulation and cell migration. TB-500 represents only a short fragment of that protein and does not include the remaining residues. Whether the isolated fragment reproduces the full range of activities reported for the intact protein remains an open question. Researchers commonly treat the two as related but distinct entities when comparing results.
=== Musculocontractural === Musculocontractural EDS (mcEDS) is characterized by congenital multiple contractures, characteristically adduction-flexion contractures and/or talipes equinovarus (clubfoot), characteristic craniofacial features, which are evident at birth or in early infancy, and skin features such as skin hyperextensibility, bruising, skin fragility with atrophic scars, and increased palmar wrinkling. It can be caused by variations in the CHST14 gene. Some other cases can be caused by variations in the DSE gene. As of 2021, 48 individuals have been reported to have mcEDS-CHST14, while 8 individuals have mcEDS-DSE.
Plutonium was first synthesized in 1940 and isolated in 1941 by chemists at the University of California, Berkeley. The Manhattan Project began shortly after the discovery, with most early research (pre-1944) carried out using small samples manufactured using the large cyclotrons at the Berkeley Rad Lab and Washington University in St. Louis. Much of the difficulty encountered during the Manhattan Project regarded the production and testing of nuclear fuel. Both uranium and plutonium were eventually determined to be fissile, but in each case they had to be purified to select for the isotopes suitable for an atomic bomb. With World War II underway, the research teams were pressed for time. Micrograms of plutonium were made by cyclotrons in 1942 and 1943. In late 1943 Robert Oppenheimer is quoted as saying "there's only a twentieth of a milligram in existence." By his request, the Rad Lab at Berkeley made available 1.2 mg of plutonium by the end of October 1943, most of which was taken to Los Alamos for theoretical work there. The world's second reactor, the X-10 Graphite Reactor built at a secret site at Oak Ridge, would be fully operational in 1944. In November 1943, shortly after its initial start-up, it produced a minuscule 500 mg. However, this plutonium was mixed with large amounts of uranium fuel and destined for the nearby chemical processing pilot plant for isotopic separation (enrichment). Gram amounts of plutonium would not be available until early 1944.
Critics such as Noam Chomsky argue continuing research into symbolic AI will still be necessary to attain general intelligence, in part because sub-symbolic AI is a move away from explainable AI: it can be difficult or impossible to understand why a modern statistical AI program made a particular decision. The emerging field of neuro-symbolic artificial intelligence attempts to bridge the two approaches.
Sources: en.wikipedia.org
=== OAS === During that month of September, Castillo met with Luis Almagro, secretary general of the Organization of American States (OAS), in Washington. Almagro offered his support for the implementation of public policies. In October 2022, following Castillo's request to the OAS to send a mission to Peru arguing that there was an alleged coup attempt by the opposition, the OAS sent a high-level group to visit Peru, analyze the situation, and seek dialogue between both sides, while also questioning the figure of the moral incapacity vacancy. Because of this, Castillo expressed his approval of the OAS's actions through his social media accounts.
== Career == In 2001, Strahl joined the University of North Carolina at Chapel Hill as an assistant professor in the Department of Biochemistry and Biophysics. He was promoted to associate professor in 2008 and full professor in 2014. He also holds an appointment at UNC’s Lineberger Comprehensive Cancer Center and is a faculty member in the Curriculum in Genetics and Molecular Biology. Additionally, Strahl also serves as the faculty director of the UNC High-Throughput Peptide Synthesis and Array Core Facility From 2016 to 2020, he served as the Vice Chair of the Department of Biochemistry & Biophysics at UNC. From 2020 to 2022, he stepped into the role of Interim Chair of Biochemistry and Biophysics. Since 2023, Strahl has held the position of Assistant Dean for Research in the Office of Research at the University of North Carolina School of Medicine. The primary mission of the Office of Research is to develop and implement a strategic plan for research in the School of Medicine(reference). The UNC School of Medicine selected Strahl as an Oliver Smithies Investigator in recognition of his research contributions. This annual award recognizes senior faculty members who have gained international recognition for their work. Since 2015, Strahl has directed UNC's Program on Chromatin and Epigenetics, aiming to understand the complex language of epigenetic regulation. The program seeks to advance human health and address diseases. Stahl is also co-founder of EpiCypher, Inc. – a company known for services for chromatin biology and epigenetics research.
== Receptor oligomers == Heteromerization with other G protein-coupled receptors (GPCRs) produces complexes with differing ligand selectivity and signaling properties. They show altered G protein coupling, receptor trafficking, and tissue distribution compared to homodimers. Targeting specific KOR-containing heteromers with bivalent ligands may yield analgesics with fewer dysphoric effects, which could be relevant for addiction research and therapy. Heterodimer of KOR with δ-opioid receptor (DOR) is proposed to underlie the pharmacologically defined κ1 subtype and explain region-specific effects like analgesia or dysphoria. Besides KOR-DOR the receptor heterodimerizes with μ-opioid (preferentially forms in females), nociceptin (NOP), orexin receptor 1 (OX1), dopamine transporter (DAT), neurotensin 1, bradykinin B2, beta-2 adrenergic receptors, GPR88. With others possible but not yet definitely established.
=== Susceptibility data === Tigecycline targets both Gram-positive and Gram-negative bacteria including a few key multi-drug resistant pathogens. The following represents MIC susceptibility data for a few medically significant bacterial pathogens.
Sources: en.wikipedia.org
The dry powder is normally kept at -20 °C, protected from light and moisture. Reconstituted solutions are often divided into aliquots and stored at -80 °C to reduce freeze-thaw damage.
Reverse-phase HPLC assesses purity, and mass spectrometry confirms molecular mass. The combination helps distinguish the target peptide from truncated or modified impurities.
Buffer composition, pH, adsorption to containers, and freeze-thaw history can all affect the amount of intact peptide in solution. These factors may change results even when the starting material is chemically correct.
Divide it into single-use aliquots and hold them frozen at -20 °C or below, protected from light. Repeated thawing of one container is the main avoidable source of variability.