The short version of Sublimation fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-04-19 and is reviewed periodically as new material appears.
Lyophilization removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts liquid water into ice and concentrates dissolved solids. Primary drying then lowers chamber pressure so ice changes directly into vapor without passing through a liquid phase. Secondary drying raises the shelf temperature to remove bound water that remains after ice sublimation. The result is a dry, porous structure that can be reconstituted later.
Formulation composition influences whether freeze-drying produces an intact cake or a collapsed mass. Excipients such as sugars and polymers can raise the collapse temperature and provide bulk during drying. The critical temperature for primary drying is often the collapse temperature or the glass transition temperature of the maximally concentrated phase. If the product temperature exceeds this threshold, the frozen matrix may soften and lose structure. Established practice therefore links shelf temperature and chamber pressure to the formulation's thermal properties.
Quality control for lyophilized materials includes visual inspection, residual moisture measurement, and reconstitution testing. Cake appearance can reveal process problems such as collapse, shrinkage, or meltback, although appearance alone does not prove potency. Residual moisture is commonly measured by Karl Fischer titration or by loss on drying. Reconstitution time is checked because a slow or incomplete dissolve can indicate a change in pore structure. Stability studies track these attributes over time under defined temperature and humidity conditions.
Analytical methods for lyophilized solids must account for the low moisture content and the fragile cake. Karl Fischer titration is widely used for water content, while near-infrared spectroscopy can measure moisture non-destructively in sealed containers. X-ray diffraction and modulated differential scanning calorimetry help identify crystalline or amorphous phases. Residual solvent analysis may be needed if organic solvents were used during formulation. The combination of these methods supports batch release and long-term stability assessment.
| Property | Value | Notes |
|---|---|---|
| Common name | Freeze-drying | Process removes water by sublimation under vacuum. |
| Typical primary drying shelf temperature | -40 C to -10 C | Set below the formulation's collapse temperature. |
| Typical chamber pressure | 0.05-0.3 mbar | Low pressure allows ice to sublime below its triple point. |
| Water content after drying | 0.5-3% by weight | Higher values may reduce storage stability for some materials. |
| Key thermal parameter | Collapse temperature | Measured by freeze-drying microscopy or differential scanning calorimetry. |
Weapon No. 2, which underwent something other than normal release from the aircraft, evidenced by the fact that the parachute did not deploy, also had its arming rods extracted, and those components which were given the opportunity to act, did act in the manner expected. Full operation of this weapon was prevented by several things: Impact occurred so soon after separation of the Bisch rods that the timers were not given an opportunity to run down. The Arm/Safe Switch was in the "Safe" condition as the weapon left the aircraft. Another analysis by Sandia engineers in 1961 concluded that while in both weapons the MC-772 Arm/Safe Switch operated "as it was designed to do," the lanyard-controlled safing-pins "cannot be relied upon to prevent initiation of the fuzing sequence" in this kind of accident, and recommended implementing a modification to the weapons "as rapidly as possible" that would prevent the fuze power supply from activating except when live release was intended. A 1969 analysis by Sandia supervisor Parker F. Jones concluded that the Goldsboro accident illustrated that "the Mk 39 Mod 2 bomb did not possess adequate safety for the airborne alert role in the B-52."
Quantitative studies of enzymatic reactions often found that the acceleration of chemical reaction speed cannot be fully explained by existing theories like the approximation, acid/base catalysis and electrophile/nucleophile catalysis. And there is an obvious paradox: in reversible enzymatic reaction if the active site perfectly fits the substrates then the backward reaction will be slowed since products cannot fit perfectly into the active site. So conformational distortion was introduced and argues that both active site and substrate can undergo conformational changes to fit with each other all the time.
In 1988, Bio-Synthesis helped in the synthesis and characterization of a new class of peptides with novel antimicrobial properties discovered at the NIH. In 1989, OCS became incorporated as Bio-synthesis, Inc. and moved its laboratories to Lewisville, Texas. In 1993, Bio-Synthesis was one of the first peptide synthesis companies to acquire a Finnigan MALDI-TOF mass spectrometer for the accurate quality control of synthetic peptides produced in-house. In 1994, Bio-synthesis pioneered the use of molecular methods for HLA analysis which is applied in organ matching for transplantation purposes. Later in the same year Bio-Synthesis held the first major HLA DNA typing workshop with the attendance of HLA laboratory directors from around the country in conjunction with University of North Texas in Denton Texas.
The Oddo–Harkins rule holds that elements with even atomic numbers are more common than those with odd atomic numbers, with the exception of hydrogen and beryllium. This rule argues that elements with odd atomic numbers have one unpaired proton and are more likely to capture another, thus increasing their atomic number. In elements with even atomic numbers, protons are paired, with each member of the pair offsetting the spin of the other, enhancing stability. All the alkali metals have odd atomic numbers and they are not as common as the elements with even atomic numbers adjacent to them (the noble gases and the alkaline earth metals) in the Solar System. The heavier alkali metals are also less abundant than the lighter ones as the alkali metals from rubidium onward can only be synthesised in supernovae and not in stellar nucleosynthesis. Lithium is also much less abundant than sodium and potassium as it is poorly synthesised in both Big Bang nucleosynthesis and in stars: the Big Bang could only produce trace quantities of lithium, beryllium and boron due to the absence of a stable nucleus with 5 or 8 nucleons, and stellar nucleosynthesis could only pass this bottleneck by the triple-alpha process, fusing three helium nuclei to form carbon, and skipping over those three elements.
Sources: en.wikipedia.org
Clinical trial number NCT02609776 for "Study of Amivantamab, a Human Bispecific EGFR and cMet Antibody, in Participants With Advanced Non-Small Cell Lung Cancer (CHRYSALIS)" at ClinicalTrials.gov Clinical trial number NCT04487080 for "A Study of Amivantamab and Lazertinib Combination Therapy Versus Osimertinib in Locally Advanced or Metastatic Non-Small Cell Lung Cancer (MARIPOSA)" at ClinicalTrials.gov Clinical trial number NCT04988295 for "A Study of Amivantamab and Lazertinib in Combination With Platinum-Based Chemotherapy Compared With Platinum-Based Chemotherapy in Patients With Epidermal Growth Factor Receptor (EGFR)-Mutated Locally Advanced or Metastatic Non- Small Cell Lung Cancer After Osimertinib Failure (MARIPOSA-2)" at ClinicalTrials.gov Clinical trial number NCT04538664 for "A Study of Combination Amivantamab and Carboplatin-Pemetrexed Therapy, Compared With Carboplatin-Pemetrexed, in Participants With Advanced or Metastatic Non-Small Cell Lung Cancer Characterized by Epidermal Growth Factor Receptor (EGFR) Exon 20 Insertions (PAPILLON)" at ClinicalTrials.gov
Because protein chains are open, AlphaKnot uses closure procedures before applying knot invariants. Its probabilistic method repeatedly closes the chain using randomly selected points on a large surrounding sphere and assigns the dominant topology obtained from the ensemble of closures. Deterministic alternatives connect the chain termini using prescribed geometries, including a direct closure and a closure constructed using the centre of mass. Knot identification uses the HOMFLY polynomial to distinguish knot types. AlphaKnot recognizes knots with minimal representations containing up to 12 crossings. In large-scale database calculations, structures that exhibit evidence of a nontrivial knot are subsequently analysed to determine the corresponding knot core, the smallest portion of the protein chain required to retain the detected topology. The database primarily reports the topology of the complete protein chain. More detailed information about subchain topologies can be obtained by calculating a knot map, which records the topology of different portions of the sequence. Because producing full knot maps for hundreds of thousands of structures would require substantial computational resources, these calculations are performed on demand rather than precomputed for the entire AlphaFold DB v4 dataset.
Alexander Butlerov Institute of Chemistry trains students for school chemical Olympiads of the Republic of Tatarstan and the Russian Federation. At various times, professors of the Institute of Chemistry headed Russian teams at International School Chemistry Olympiad among them were Andrey N. Vedernikov, Arkady I. Kuramshin and Igor A. Sedov; The old building of the Alexander Butlerov Institute of Chemistry since it was built in 1953, was not only a laboratory building of chemical faculty of Kazan University, at different times, it also placed historical-philological faculty of Kazan University, military department, some rooms were used as a hostel for young teachers and graduate students of the University.
SNX8 role in cholesterol levels regulation is markedly relevant since disruption of intracellular cholesterol metabolism and trafficking is the main cause of multiple human disorders. For example, some studies suggest that SNX8 deletions might produce cardiac malformations since its function in normal cholesterol levels regulations would be completely impaired. SNPs (single nucleotide polymorphisms) in the SNX8 gene are related to neuropathy due to its role in endosomal content sorting. Neuropathic pain is a chronic debilitating pain condition caused by a nervous system lesion or dysfunction, which usually emerges after head and neck cancer treatment. This hypothesis is supported by the fact that other SNXs activity has also been identified with other pain conditions.
Some anesthetics and chemotherapy drugs are injected intrathecally into the subarachnoid space, where they spread around CSF, meaning substances that cannot cross the blood–brain barrier can still be active throughout the central nervous system. Baricity refers to the density of a substance compared to the density of human cerebrospinal fluid and is used in regional anesthesia to determine the manner in which a particular drug will spread in the intrathecal space. Liquorpheresis is the process of filtering the CSF in order to clear it from endogen or exogen pathogens. It can be achieved by means of fully implantable or extracorporeal devices, though the technique remains experimental today.
Sources: en.wikipedia.org
A/B testing (also known as bucket testing, split-run testing or split testing) is a user-experience research method. A/B tests consist of a randomized experiment that usually involves two variants (A and B), although the concept can be also extended to multiple variants of the same variable. It includes application of statistical hypothesis testing or "two-sample hypothesis testing" as used in the field of statistics. A/B testing is employed to compare multiple versions of a single variable, for example by testing a subject's response to variant A against variant B, and to determine which of the variants is more effective. Multivariate testing or multinomial testing is similar to A/B testing but may test more than two versions at the same time or use more controls. Simple A/B tests are not valid for observational, quasi-experimental or other non-experimental situations—commonplace with survey data, offline data, and other, more complex phenomena.
Aldo Carl Leopold (December 18, 1919 – November 18, 2009) was an American academic and plant physiologist, son of Aldo Leopold, a noted ecologist. He is known for his research on soybeans which led to techniques allowing insulin to be dried and later processed into an inhalable insulin. Aldo Carl Leopold was born to Aldo Leopold, a noted ecologist and employee of the United States Forest Service, and Estella Leopold in Albuquerque, New Mexico as the 4th of 5 children.
Aviation Safety Network Established in 1996. The ASN Safety Database contains descriptions of over 15800 airliner, military and corporate jet aircraft accidents/incidents since 1921. Bureau of Aircraft Accidents Archives Established in 2000. The B3A contains descriptions of over 22,000 airliner, military and corporate jet aircraft accidents since 1918. National Transportation Safety Board Aviation Accident Synopses – by month Aviation Statistics Statistical and geospatial analysis of general aviation accidents. Aviation Accidents App Access the NTSB Aviation Accidents Database and Final Reports from all over the world on your mobile device Aviation Accidents Map Explore an interactive map showcasing airplane crash sites Air Crash Map | Interactive Aviation Accident Database
In terms of dosage equivalence, norethisterone and NETA are typically used at respective dosages of 0.35 mg/day and 0.6 mg/day as progestogen-only contraceptives, and at respective dosages of 0.5–1 mg/day and 1–1.5 mg/day in combination with ethinylestradiol in combined oral contraceptives. Conversely, the two drugs have been used at about the same dosages in menopausal hormone therapy for the treatment of menopausal symptoms. NETA is of about 12% higher molecular weight than norethisterone due to the presence of its C17β acetate ester. Micronization of NETA has been found to increase its potency by several-fold in animals and women. The endometrial transformation dosage of micronized NETA per cycle is 12 to 14 mg, whereas that for non-micronized NETA is 30 to 60 mg.
Sources: en.wikipedia.org
Primary drying removes ice by sublimation at low pressure and low shelf temperature. Secondary drying removes bound water by raising the shelf temperature, often under the same vacuum. The two stages differ in the water state being removed.
Freezing determines ice crystal size, pore structure, and the concentration of solutes in remaining liquid. Faster freezing generally creates smaller ice crystals and a denser dried matrix. These features affect drying rate and reconstitution behavior.
Lyophilization reduces water content but usually leaves a small amount of water in the dried material. Some water remains bound to solids or trapped in the dried matrix. Very low water targets can require extended secondary drying, which may alter product stability.
Most lyophilized products are stored in sealed containers at controlled temperature and humidity. Some require refrigeration, while others are stable at room temperature. Protection from light and moisture is often necessary.